Difference between revisions of "Fs2 open on Linux/Pre-Compile Configuration"
(he slams it down right ...) |
(Page Navigation) |
||
| Line 1: | Line 1: | ||
| + | {{Page Navigation| | ||
| + | BookName=[[Fs2 open on Linux]]| | ||
| + | CurrentPage=Pre-Compile Configuration|Pre-Compile Configuration| | ||
| + | PrevPage=[[Fs2_open on Linux/Checkout Script|Checkout Script]]| | ||
| + | NextPage=[[Fs2_open on Linux/Optimization|Optimization]]}} | ||
| + | |||
{{Note| This step is only for those who want the bleeding-edge source code to compile on their own. You can skip this if you intend to use a provided binary executable.}} | {{Note| This step is only for those who want the bleeding-edge source code to compile on their own. You can skip this if you intend to use a provided binary executable.}} | ||
Before you compile you need to configure it for your system. In the directory you ran the CVS command from, a new directory has appear, namely fs2_open. | Before you compile you need to configure it for your system. In the directory you ran the CVS command from, a new directory has appear, namely fs2_open. | ||
Revision as of 21:48, 3 September 2007
| « Checkout Script | Fs2 open on Linux Pre-Compile Configuration |
Optimization » |
Before you compile you need to configure it for your system. In the directory you ran the CVS command from, a new directory has appear, namely fs2_open. If your fs2_open is a completely new checkout, you will first need to run the autogen.sh script. Run from inside your newly created fs2_open directory:
$ ./autogen.sh
autogen.sh is a script that will generate the required makefiles. You will see alot of "checking for this" and "checking for that", this is actually the "configure" script (which can be run with ./configure if you need to change the options) examining and configuring fs2_open for your system.
It is possible to give autogen.sh configure options as well, autogen.sh will pass them along to configure.
A full list of configure options can be found by running the configure script with the '--help' option.
$ ./configure --help
